Twin Stim (2nd) Digital TENS+EMS Kit

InTENSity #DS2202 Digital Combo TENS/EMS Kit with Timer

The Twin Stim 2nd Edition Digital TENS & EMS Combo is a portable, easy-to-use device, combining TENS (Transcutaneous Electrical Nerve Stimulation) with EMS (Electrical Muscle Stimulation) electrotherapy, allowing many options to address pain.

 

• Relieve your pain by using the TENS Mode.
  • TENS is a non-invasive, drug free method to control your pain by sending tiny electrical impulses through the skin to target the nerves. In many cases, this stimulation will greatly reduce or eliminate pain.
• Strengthen your muscles by using the EMS Mode.
  • EMS is widely used in hospitals and sports clinics to treat muscle injuries, to re-educate paralyzed muscles, and to prevent atrophy in affected muscles.

Product Features:

• Channels: Dual Channel
• Pulse Amplitude: Adjustable, 0-100 mA
• Voltage: 0 - 50V (Load: 500 ohm)
• Pulse Rate: Adjustable, from 2 to 150 Hz, 1 Hz/step
• Pulse Width: Adjustable, from 50 to 300 microseconds, 10µS/step
• Wave Form: Asymmetrical Bi-Phasic Square Pulse
• On Time: Adjustable, 2~90 seconds, 1 Sec./ step
• Off Time: Adjustable, 2~90 seconds, 1 Sec./ step
• Ramp Time: Adjustable, 1~8 seconds, 1 Sec./ step, The "On" time will increase and decrease in the setting value.
• Patient Compliance Meter: This unit can store 60 sets of operation records. Total recorded time is 999 hours.
• Timer: Adjustable, from 5 to 60 minutes or Continuous. Adjustable in 5 minutes each step. Treatment time counts down automatically.
• 1 Year Manufacturer Warranty
• Package comes with everything you need to start treatment right away.
  • 1x Twin Stim 2nd Edition Stimulator
  • 45" Lead Wires
  • 1x Pack of Four High Quality Self-Adhesive Electrodes
  • 1x 9V Battery
  • Hard Plastic Carrying Case
  • Instruction Booklet

Product Specifications:

• 2 EMS Modes:
  • Synchronous: Stimulation of both channels occurs synchronously. The "ON" time including "Ramp Up" and "Ramp Down" time. Therefore, the setting of ON Time should be no less than two times of the "Ramp" time in this mode. ON TIME Ramp up + Ramp down
  • Alternate: The stimulation of CH2 will occur after the 1st contraction of CH1 is completed. In this mode, the setting of ON Time should be no less than two times of the "Ramp" time. The OFF Time should be equal to, or more than, the ON Time. ON TIME Ramp up + Ramp down OFF TIME ON.

• 5 TENS Modes:
  • Burst Mode (B): Burst rate: Adjustable, 0-5 5Hz; Pulse width adjustable, 50~300uS; Frequency fixed = 100 Hz
  • Normal Mode (N): The pulse rate and pulse width are adjustable. It generates continuous stimulation based on the setting value.
  • Modulation (M) mode is a combination of pulse rate and pulse width modulation. The pulse rate and width are automatically varied in a cycle pattern. The pulse width is decreased by 50% from its original setting in 0.5 second, then the pulse rate is decreased by 50% from its original setting in 0.5 second. Total cycle time is 1 second. In this mode, pulse rate(2-150Hz) and pulse width(50-300S) are fully adjustable.
  • The SD1 (Strength-Duration) mode consists of automatic modulation intensity and pulse width in 40% range. The intensity is always increasing while the pulse width is decreasing and vice-versa. The intensity is decreased by 40% while the pulse width is increased by 40% in 5 seconds. In the next 5 seconds, the intensity is increased by 40% while the pulse width is decreased by 40%. Total cycle time is 10 seconds. Pulse rate(from 2~150Hz) and pulse width (from 50~300S) are fully adjustable.
  • The SD2 (Strength-Duration) mode consists of automatic modulation intensity and pulse width in 70% range. The intensity is always increasing while the pulse width is decreasing and vice-versa. The intensity is decreased by 70% while the pulse width is increased by 70% in 5 seconds. In the next 5 seconds, the intensity is increased by 70% while the pulse width is decreased by 70%. Total cycle time is 10 seconds. Pulse rate(from 2~150Hz) and pulse width (from 50~300S) are fully adjustable.

WARNING: CANCER & REPRODUCTIVE HARM; PROP 65 WARNING INFO

Proposition 65 requires businesses to provide warnings to Californians about significant exposures to chemicals that cause cancer, birth defects or other reproductive harm. These chemicals can be in the products that Californians purchase, in their homes or workplaces, or th??at are released into the environment. By requiring that this information be provided, Proposition 65 enables Californians to make informed decisions about their exposures to these chemicals.

Are any businesses exempt from Proposition 65’s requirements?

YES. Businesses with less than 10 employees and government agencies are exempt from Proposition 65’s warning requirements and prohibition on discharges into drinking water sources.  Tartan Group is exempt from Proposition 65 requirements as our business has fewer than 10 employees, however, we feel that it is important to warn CA residents of the possibility that some of our products may contain chemicals that cause cancer, birth defects or other reproductive harm.

More Specific Information about Businesses and Proposition 65:

https://oehha.ca.gov/proposition-65/businesses-and-proposition-65

Proposition 65 also prohibits California businesses from knowingly discharging significant amounts of listed chemicals into sources of drinking water.

Proposition 65 requires California to publish a list of chemicals known to cause cancer, birth defects or other reproductive harm. This list, which must be updated at least once a year, has grown to include approximately 900 chemicals since it was first published in 1987.

Proposition 65 became law in November 1986, when California voters approved it by a 63-37 percent margin. The official name of Proposition 65 is the Safe Drinking Water and Toxic Enforcement Act of 1986.

For More General Information About Proposition 65, please click the link below:

https://oehha.ca.gov/proposition-65